It sounds like you have a Drive # 324-000002 RV camera system. If you want to replace the entire system you can order the # 324-000002 again. The rear camera alone is not available. If you have been satisfied with this system you can use it again, but a better choice is the Furrion # FOS05TASF system with 5" monitor screen. view full answer...
I found a couple options available for your 2008 Fleetwood Tioga Motorhome on the Ford Chassis. the fsn-21-9015 is the item number for the sticker used on many of the Firestone Ride-Rite systems. Both the replacement air bags are per bag so if you need both sides you will need 2 of the correct air bags.
To identify the correct replacement air bag you will need to identify if your air bag is mounted above the leaf spring like the Ride-Rite Air Helper Springs # F2153 are or if they are... view full answer...
The Adco SFS AquaShed Cover for SUVs - 196" Long Item # 290-12285 is not compatible for your 2004 GMC Yukon XL. I recommend the Covercraft Polycotton Custom-Fit Indoor Vehicle Cover - Gray Item # C15792PD view full answer...
I looked up pictures of your 1994 Fleetwood Tioga and it has a standard door mounted mirror like the CIPA part # CM45000 is designed to replace so this would work well for you. view full answer...
Yes, the RV interior light part # 328-001-902XPW that you referenced is the standard style of RV interior light you are referring to. The most similar light we have to it is the part # RVIL22. view full answer...
Yes we can definitely set you up. I recommend the Furrion HE # FR92PR. This is a complete Ac system and will work with the original ducts. I really like these Furrion Ac units because they are efficient and quiet. If the unit you are replacing is original from 2006, this will be a major upgrade.
I have linked an installation video below if you want to take a look. view full answer...
The Lippert Manual Pull-Out Step for RV's, # LC432682, as shown in the attached product review video, has a center-on-center hole measurement of 7" and 24". view full answer...
The Valterra Entry Door Window Frame Assembly - Exterior - Black # A77051 you were looking at is just the exterior frame. The # A77012 you mentioned is the interior side of the frame.
If you are needing to replace both of the interior and exterior frames I recommend going with the Deluxe Window Frame for RV Entry Doors - Black # 37211021 which includes both the interior and exterior frames, but you will need to purchase the mounting hardware # A7704812 separately.
The frames mentioned... view full answer...
Since there isn't a different set of brackets for use with the Mount-n-Lock Heavy-Haul'r RV Bumper Replacement Kit # MO44VR you'd have to look into having the hitch lowered to allow the bumper to fit with it. RV hitch fits are known to be somewhat challenging so this type of modification is not totally out of the ordinary. view full answer...
We do offer teardrop style clearance lights in red, the Pacer Performance Hi-Five Truck Cab Light Kit part # PP20-215 which are sold as a set of five. These lights by law must be installed so that they face the rear of your vehicle. They come with the switch and all other hardware needed for installation. view full answer...
If you live in Southern California, I recommend going with an all-weather model of wiper blades since you will not need any wipers that are made specifically for ice and snow. For your 2005 Fleetwood Tiogo Motorhome 31K-SL, I recommend purchasing 2 Michelin Cyclone Windshield Wiper Blade - Hybrid Style - Soft Cover - 20" # MCH14520. The Michelin Cyclone blades are a hybrid model that is not specifically made for one type of weather element. Therefore, the Cyclone blades will allow you to... view full answer...
Yes, we do have locking t-handles. I recommend the Bauer Products T-Handle Lock for Truck Caps item # BA47VR. This t-handle is 3-1/2" long x 2" wide, the length of shaft is 2", and the distance between mounting holes center to center is 1-1/2". view full answer...
Technically, anything is possible with a bit of redneck engineering, but in this case I would recommend at least getting some sort of solid steel tubing that you could drill holes in to take up the gap left between the bumper and the brackets for the 24x60 etrailer Cargo Carrier for RV Bumper # e99049.
Using just washers would most likely point too much pressure at one point and fail. Since you're not using the product as intended there wouldn't be a warranty to fall back on if anything... view full answer...
I have a solution for you, but the Roadmaster # RM-1139-163 is not the correct fit for your 2009 Fleetwood Tioga. Instead, you'll need the # RM-1139-147.
I've linked an installation video of this for you to check out, as well. view full answer...
Depending on the measurements of your existing microwave we may have a few options that work for you. I did some research and was unable to find measurements of your existing microwave.
The Greystone Standard RV Microwave w/ Trim Kit # 324-000106 is a built-in microwave that measures in at 23 3/8" wide, 15" tall, 14 1/4" deep and is 1,350 watts with a capacity of 0.9 cubic feet.
Or
You can go a little larger with # FMCM15SS which measures 29-15/16" wide, 16-3/8" tall 15" deep, is rated... view full answer...
The Gustafson RV Puck Light, 5" Surface Mount with 18 LEDs at 4 Watts # 277-000341 is a 12V light that is installed in a circuit either singularly or in multiples. The circuit will require a switch and is compatible with a dimmer switch.
However, we do have the LED RV Interior light with a built-in switch and 36 Diodes that is also a surface mount # 3375625337. This is a 5-1/8" light, which is so close to a 5". view full answer...
We carry a few different types/styles of flush mounted cabinet hinges so I've listed each below to help you find what you're looking for:
Free-Swinging:
Satin Nickel # 37270655
Brass # 37270615
Antique Brass # 37270605
Self-Closing:
Antique Brass # 37270585
Satin Nickel # 37270575
Brass # 37270595
Non-Mortise:
Satin Nickel # 37270635
Chrome # 37270645
Spring Support:
Steel # 37270705 view full answer...
Tow bars don't last forever unfortunately. If yours has had 20 years of constant use it would be time to replace the whole thing. Roadmaster typically recommends their tow bars get replaced at 8-10 years and a max of 80k miles.
The Roadmaster Falcon 2 part # RM-520 would be a great choice for a new tow bar that will be very easy to use. It's essentially the new and updated version of your current Falcon. view full answer...
The closest I was able to find for your 2004 Fleetwood Tioga 29V is the Bauer Products Rotary Latch for Horse and Utility Trailers # BA85FR, which measures 7-3/8" long, 1-7/8" wide, and 7-3/4" tall.
This latch is a bit taller than your original latch dimensions, but if you're willing to make some minor alterations you could make it work.
This will work great with doors that are 1-1/2" thick, and will fit into cutout openings measuring 6" tall and 4" wide. view full answer...
We have one replacement damper that is pretty close to what you mentioned with the part # BCA0472-00 but this measures 9-7/16" long x 4-1/2" wide so it's about 1 inch less tall than what you mentioned. view full answer...